Date: 2009-10-14 22:14 Author: pass4line Click: 45
Pass4side Cisco 642-731 exam brain dumps
1. Construction of a new automobile parts manufacturing facility has recently been completed. The facility IT manager wants to deploy voice over WLAN. During your initial walkthrough, you observe numerous highly reflective surfaces on the manufacturing equipment and in the building construction itself. What potential problem exists that should be accounted for during your site survey?
A. LOS modulation
B. multipath distortion
C. RF signal absorption
D. RF signal attenuation
E. Fresnel zone impedance
Answer: B
2. To which parameter should the access point be set during a site survey?
A. transmit only
B. diversity
C. receive only
D. single isolated antenna
Answer: B
3. Which statement is true when using a Cisco Wireless Mesh Networking Solution?
A. The backhaul link is dynamic 1 to 54 Mb/s.
B. The backhaul link is typically a fixed value.
C. The backhaul link uses DAS antennas.
D. The backhaul link uses antenna multiplexing.
E. The backhaul link does not rely on fade margin.
Answer: B
4. How many access points will a Cisco 7600 Series Router with six installed Cisco Catalyst 6500 Series Wireless Services Modules support?
A. 300
B. 448
C. 664
D. 1800
E. 2400
Answer: D
5. Which value is NOT supported by Cisco Spectrum Expert, when checking for RF coverage?
A. access point received-signal strength level
B. spectrum utilization
C. client data rate
D. in-band radio frequency interference
Answer: C
6. Which is NOT part of a typical wireless site survey?
A. implementation suggestions
B. access point locations
C. security requirements
D. access point mounting methods
Answer: C
The latest exam in Pass4side:Cisco 646-671 exam,ISEB BH0-007 exam,EMC e22-280 exam and HP HP0-M25 exam.